Commercial Roof Repair Across Texas & Louisiana

We fix the leak you have, not the roof you don't need.

★★★★★ 4.91,400+ Google reviews20,000+ roofs replaced

Serving Texas & Louisiana Since 1983

M&M diagnoses and repairs leaks, membrane damage, failed seams, flashing, drainage components and rooftop penetrations on commercial roofs throughout Texas and Louisiana. We work on TPO, modified bitumen, metal and coated roof systems, with repair recommendations based on the condition of the entire roof, not only where water appears inside.

Licensed, insured & bonded

Get a Free Commercial Assessment

No cost, no obligation. We will contact you within one business day.

Step 1 of 2 - How Should We Contact You?

This field is for validation purposes and should be left unchanged.
First Name
Last Name

Free assessment · No obligation · Serving Texas & Louisiana since 1983

Privacy Policy · Terms & Conditions

GAF President's Club

GAF Master Elite

Google 4.9-star rating, 1,400+ reviews

Angi Super Service Award

BBB Accredited A+ Rating

Commercial roof problems M&M repairs

M&M repairs active leaks, seam and membrane damage, failed flashing, drainage problems, storm damage and recurring leaks on commercial roofs across Texas and Louisiana.

Active leaks and interior water stains

Water can travel along the deck, insulation or conduit before it appears inside, so a stain is not always directly below the opening. We trace it back to the roof before recommending a repair.

Open seams, laps and membrane punctures

Heat cycling, foot traffic and dropped tools can open laps or puncture the membrane. Isolated damage is often repairable while the surrounding membrane remains serviceable.

Failed flashing around penetrations and rooftop equipment

Pipe boots, HVAC curbs, vents, skylights and newly installed equipment are frequent leak sources when flashing deteriorates or was not detailed for the roof system.

Ponding water and drainage problems

Water that stays on the roof long after rain can point to clogged drains, low spots or compressed insulation. Clearing drains and correcting slope can often resolve it.

Wind, hail and storm damage

Uplift, loosened fasteners and hail impacts do not always cause an immediate leak or show from the ground. An inspection after a major storm documents conditions for repair planning and insurance.

Recurring leaks or failed previous repairs

When the same area keeps leaking, the original source may not have been found. We re-evaluate the surrounding area rather than adding another patch over the last one.

What a commercial roof repair includes

Each repair covers three stages: finding the source, fixing it and documenting what was done. If your roof is still under a manufacturer warranty, tell us before the visit. Some warranties require specific repair methods or an authorized contractor, and we will review the terms with you before any work begins.

Diagnosis

  • Interior leak and moisture review
  • Exterior roof-condition inspection
  • Examination of seams, flashing, drains and penetrations
  • Photographic documentation
  • Additional testing when the source is not visually apparent

Repair work

  • Membrane and seam repairs
  • Flashing and penetration repairs
  • Drainage corrections
  • Localized insulation or decking replacement
  • Temporary weather protection when appropriate

Documentation and closeout

  • Written repair scope
  • Before-and-after photographs
  • Description of completed work
  • Applicable workmanship or material warranty
  • Maintenance or monitoring recommendations

Repair, restore or replace?

A leak does not automatically mean a commercial roof needs replacement. These conditions typically point one way or the other; an on-roof assessment confirms which apply to your building.

Repair is more likely whenRestoration or replacement may be needed when
Damage is isolatedLeaks occur across several roof areas
Surrounding membrane remains serviceableLarge sections of insulation are saturated
Decking remains structurally soundDecking has widespread deterioration
The system has useful service life remainingThe system is near the end of its service life
Previous repairs are limitedThe same areas have repeatedly failed

Restoration, such as a coating system, may be an option when the membrane is aged but the insulation and deck are largely dry. Even when replacement is the longer-term answer, a repair may still be needed to stop active water entry.

How M&M diagnoses a commercial roof leak

Patching where water appears inside is why leaks come back. We find the source first, then recommend the repair.

01

Review where and when the leak appears

We ask when water shows up (heavy rain, wind-driven rain, or only when equipment runs) and where it appears inside.

02

Inspect the interior and accessible roof assembly

Stain locations, deck condition and the likely path of travel narrow the area we need to search on the roof.

03

Examine likely entry points and surrounding conditions

Seams, flashing, drains, penetrations and rooftop equipment near the suspected area are checked and photographed.

04

Use additional testing when needed

If the source is not visually apparent, additional moisture testing or controlled water testing may be used to confirm it.

05

Present findings and repair options

You receive photos, a written scope and the options that fit the roof's condition, including when repair alone is not the right answer.

06

Complete, document and verify the approved repair

A system-appropriate repair for your roof type, followed by before-and-after photos and a description of the completed work.

Commercial roofing systems M&M repairs

Each system fails differently and needs compatible materials and methods. The right repair depends on the roof's condition, the building's occupancy and any existing warranty requirements.

TPO roofing

TPO and single-ply membranes

Common failure points: seam and lap separation, corner and penetration details, punctures, and shrinkage at perimeter terminations. Typical repair approach: cleaning and preparing the membrane, then heat-welded patches or seam repairs where the existing membrane will still accept a weld.

Modified bitumen

Modified bitumen

Common failure points: blisters, split laps, granule loss on the cap sheet, and deteriorated flashing at walls and curbs. Typical repair approach: removing damaged material and installing compatible patches or flashing, with the application method selected for the building and its occupancy.

Metal roofing

Commercial metal roofing

Common failure points: loose or backed-out fasteners, worn washers, open seams and end laps, corrosion at panel ends, and failed penetration flashing. Typical repair approach: fastener replacement, sealing or reflashing seams and penetrations, and replacing panel sections where corrosion has gone through.

Roof coatings

Coated roof systems

Common failure points: thin or worn areas, delamination over ponding water, and coating pulling away at curbs and penetrations. Typical repair approach: cleaning, reinforcing and recoating affected areas with a compatible coating. Broad wear may make a full recoat the better option.

Repairs around an occupied building

Repairs around an occupied building

Before the crew arrives, we plan these items with your property's representative.

Commercial repairs are normally performed during standard operating hours. M&M coordinates access, work areas and project sequencing with the property's representative to help minimize disruption.

  • Access, staging and protected entrances: crew parking, material hoisting and staging areas are planned with your building contact so entrances, loading areas and fire lanes stay usable.
  • Coordination around occupants and operations: work areas and sequencing are planned around tenants, customers and operating schedules, including HVAC intakes when work produces odor.
  • Weather planning and daily site protection: work is scheduled around the forecast, and open repair areas are protected before the crew leaves the roof each day.
  • Safety, cleanup and project communication: fall protection and site safety requirements are followed, work areas are cleaned up, and your representative is kept informed as the repair progresses.

We're trusted by our clients

★ 4.9 average · 1,400+ Google reviews

Jacob Kempnich
Jacob Kempnich
★★★★★
We just had our roof replaced by M&M Roofing in Clearlake and were very pleased with their work. Michael McCollom did a great job of explaining everything to us beforehand, including discussing options and plans, the pricing and scope was very fair and reasonable. Once we signed the contract for the work, he communicated with us promptly about dates and expectations. The crew showed up and they were extremely fast and efficient. The roof looks great, and we couldn't be happier. We highly recommend M&M Roofing Siding & Windows.
Steve Hargis
Steve Hargis
★★★★★
We had M&M come out to repair a couple of leaks in our covered patio. Greg was super helpful in diagnosing the issues, providing lots of information on how best to make the repairs and options for what we needed.


The work was completed in one day and Greg came out to make sure the crew was doing everything the way he wanted. The whole process was really great. Very professional from start to finish. Thanks M&M.
Cassandra Lazos
Cassandra Lazos
★★★★★
I recently had the pleasure of working with M&M for siding work on my house, and I must say, the experience exceeded all my expectations. From the get-go, the level of customer service was simply outstanding. A special shoutout to Sam, our representative, who was not only professional and knowledgeable but also incredibly attentive to our needs.

Sam went above and beyond to ensure that all our questions were answered, and our concerns addressed, making the entire process smooth and stress-free.
Rachel Maddoux
Rachel Maddoux
★★★★★
Tim did a great job. He picked out tile that exactly matched my roof. I only had to replace a portion of …
Brittney Richard
Brittney Richard
★★★★★
I cannot say enough good things about this roofing company! From start to finish, the entire experien…
Sam Trujillo
Sam Trujillo
★★★★★
Chris P. was prompt and knowledgeable about his product and shared wonderful insight as t…
Keith Blackford
Keith Blackford
★★★★★
Honest, professional, easy to deal with! Highly recommend.
Bill G
Bill G
★★★★★
Replaced our mid-1980s residential siding with a major-branded cement-fiber product in August…
Charlotte Childress
Charlotte Childress
★★★★★
M&M has been there for me through a new roof, siding, and gutters… they are professionals th…
Jingting Yang
Jingting Yang
★★★★★
We recently replaced our 20-year-old roof using M&M Roofing, and we couldn’t be happier with our…

Commercial roof repair FAQs

Call (800) 352-3933 and describe where water is appearing. Scheduling depends on weather, roof access and crew availability. When water is actively entering the building, temporary protection is prioritized to limit interior damage until the source can be diagnosed and repaired.

When the leak appears (heavy rain, wind-driven rain, or only when equipment runs), where water shows up inside, photos of the interior and roof, the roof's age and system type, records of previous repairs, and any warranty documents. Prior inspection reports are useful too.

Often, yes. Repair is more likely when damage is isolated, the surrounding membrane is serviceable, the insulation and deck are largely dry, and the roof has useful service life remaining. An on-roof assessment confirms whether those conditions apply.

TPO and other single-ply membranes, modified bitumen, commercial metal roofing and coated roof systems. If you do not know what is on your building, we identify the system during the inspection.

It can, if the warranty requires specific methods, materials or an authorized contractor. Share your warranty documents before the visit and we will review the terms with you, including whether the manufacturer or original installer should be contacted first.

In most cases, yes. Commercial repairs are normally performed during standard operating hours, and M&M coordinates access, work areas and sequencing with the property's representative to help minimize disruption.

When leaks occur across several roof areas, large sections of insulation are saturated, the deck has widespread deterioration, the system is near the end of its service life, or the same areas keep failing. Restoration may fit when the membrane is aged but the insulation and deck are largely dry.

Request a Commercial Roof Repair Assessment

Tell us about the building and what you are seeing. We will trace the source on the roof, give you a written repair scope with photos, and recommend the repair, or tell you if repair is not the right answer.

★ 4.91,400+ Google reviews20,000+ roofs replaced